More than Photography

If you would like to create your own mixed media/collage/photo transfer,
here is how its done:

What you need:
• Inkjet photo (printed on STANDARD PRINTER PAPER) or a laser photocopy of your photo
• Collage materials such as: newspaper or magazine clippings, designer or hand-made papers, wrapping papers, stamps, shopping bags, junk mail etc.
• Acrylic or water paints
• Any type of glue such as school glue, PVA or Mod Podge
• Any type of transfer medium such as Mod Podge or gel medium
• Canvas or wood panel
• A water spray bottle
• UV-resistant clear finish

1) Gather your collage materials and lay them out in a design of your choice on any size canvas or wood panel. Adhere the collage pieces onto the surface using school glue or mod podge.
2) If you are using mod podge make sure to cover the collage pieces with Mod Podge so it doesn’t only adhere the papers to the canvas but also protects it to all eternity (or at least a few years).

3) Once your collage is thoroughly dry you can paint it with watercolor or acrylic paints. I like to use different shades of a color, paint the center with the brightest shade and then go darker toward the edges.

4) The next step is to convert the photo of your choice to black and white. In some cases color photos will work as well but black and white often work better with this process as they stand out more over the background.
5) You can use either a xerox photocopy of your image or an image printed from your inkjet printer. If you are using an inkjet, print out a mirror version of your image into a standard printer paper (not a photo paper!).

Since I decided to work with a 16″X20″ canvas panel I had to divide my photo and print out 4 sheets of 8″X10″ papers.
6) If you are using an inkjet print its a good idea to protect your print with spray fixative to prevent smudging.

7) Next, cover your image with Mod Podge and press it face down into the collage. Rub gently with your fingers to smooth out any air bubbles.
8 ) If you are using an inkjet photo you will have to wait only about an hour or two for the Mod Podge to dry and for the transfer to complete. If you are using a photocopy let it set for a few hours, preferably over night.

9 ) Spray the back of your photo with water and gently remove and rub off the excess paper with your fingers in order to reveal the transfer. If you are using a photocopy you will have to repeat this step as many time as needed until the excess paper is completely gone.

10) At this point you will notice that there might be some paper left behind which is difficult to remove. Also the transfer looks quite rough and does not blend nicely with the background. So in order to better unify the background and the photo transfer, paint over the edges of your transfer using the same color you used for the background. Next you can paint over the white areas of your transfer with similar shades of the background behind them. Water down your paint and dub it onto the white areas with a paper towel. For the smaller areas you can use a cotton swab . Make sure not to paint over the ink (black) parts of your photo, just the white areas where the paper can still be seen.

Take a look at the next picture: The left area was painted while the right side is still covered with the white paper and had not been painted yet.

And this is the final image:

11) Preserve your art work with a protective finish such as “preserve it!” by Krylon for inkjet or Krylon Crystal Clear if you used a toner based photocopy.

You can find this photo process and many others in my new book: So Much More than Photography – eBook edition is now on sale for $10 .